decoSTAINSTOP

– Highly oil- and stain-resistant; improves abrasion resistance

– Makes the surface easier to clean

– Easy to apply; penetrates readily; walkable within ~30 minutes

– Breathable penetrating sealer — will not peel or flake like coatings

– Simple reapplication in high-traffic areas without build-up

– UV-resistant — indoor and outdoor

– Helps inhibit moss, mold and mildew outdoors

– Water-based; not moisture-sensitive

– Enhances color intensity of stone and decorative concrete

– VOC-compliant (< 10.0 g/L); non-toxic / classified as non-hazardous

Coverage (indicative, undiluted)

– Overall: about 7–40 m²/kg depending on substrate type and porosity

– Floors (spread rate per pass): about 20–40 m²/kg; always apply two coats aiming for a total of about 10–20 m²/kg

– Walls (HVLP): about 5–20 m²/kg depending on requirements

1. Surface preparation

Clean the surface; remove dust, loose particles, grease, stains or anything that blocks penetration and adhesion. Recommended prep is abrasion/sanding to clean and open the pores. Depending on the substrate, high-pressure water cleaning may also prepare the surface before application.

1. Application — floors
2. Stir and shake the container before use. On very dense concrete, dilute 1:1 with water.
3. Spray lightly with a pump sprayer or HVLP over the area to be treated.
4. Spread at about 20–40 m²/kg depending on porosity and roughness. On very smooth substrates (terrazzo, polished concrete), is best spread with a microfiber mop. Do not work the material into the surface — spread and leave.
5. Always apply two coats. Allow 15–30 minutes drying between coats. Target total consumption about 10–20 m²/kg.
6. Floor is walkable within ~30 minutes. No heavy traffic and avoid water contact for 72 hours after application.
7. Important: do not over-apply — very thin coats perform best.
8. Application — walls

Spray with HVLP at about 5–20 m² per kg depending on requirements.

Maintenance

With good cleaning, decoSTAINSTOP lasts for years. Periodic reapplication may be needed after 2+ years depending on use; as a penetrating sealer, reapplication is easy and does not build a film. Prefer regular decoCLEAN with warm water. Do not use acidic cleaners or products with citrus (d-limonene) or butyl compounds. Wipe chemical spills promptly.

Product properties (TDS indicative)

Active solids ~15% · Specific gravity ~1.02 · pH 8–9 · VOC < 10.0 g/L · Freeze point 0 °C · Shelf life 2 years in unopened factory packaging.

Mechanical / physical (treated concrete — TDS indicative)

– Abrasion: internal +30% wear resistance

– Wet SCOF ~0.67 (Anderson; ASTM criteria min. 0.5)

Packaging (TDS)

25 kg plastic can · 210 kg drum.

Need the technical or safety data sheet? Email us at info@broosindustrialfloors.com or use our contact page and we will send it right away.