decoSOD-HS1

• Makes the surface harder, more abrasion and stain resistant
• Eliminates dusting
• Very economical dustproofer and hardener for industrial floors
• High solids: can be diluted 1:1 with clean water
• Water-based, VOC-free and eco-friendly
• Internal test: +33% abrasion resistance, Mohs hardness from 4 to 6

1. Clean the surface: free of dust, loose particles, grease, stains or anything that prevents penetration. Sand to open the pores; use professional machines with suitable abrasive discs or pads on large areas.
2. Stir lightly before use; do not over-mix (foaming).
3. Optional: dilute 1:1 with clean water; use the mix the same day.
4. Spray and/or apply with microfibre; spread evenly. Approx. 5–7 m²/kg.
5. The product penetrates and dries in 15–60 minutes (longer in cool or humid weather). Remove any tacky excess with water. No traffic until dry.
6. When polishing: from resin pads grit 100, apply at least 2 layers after 2 different polishing steps; continue polishing once the surface no longer glistens.
7. Product properties (TDS indicative): Solids 30–40% · Specific gravity 1.25–1.35 · pH 10.5–11.5 · VOC < 1 g/L · Freeze point 0 °C (protect from freezing) · Shelf life 1 year in unopened factory sealed container. Packaging: 25 kg can; 200 kg drum.

Tip: Use our Densifier Applicator for fast, accurate application without spray mist.

Which concrete is decoSOD-HS1 for?

Porous concrete with high porosity. For medium-quality concrete use decoSIL; for high-quality, dense concrete use decoLIT-CS.

How much do I need?

Approx. 5–7 m²/kg. Always test a small area first.

Can I dilute it?

Yes, 1:1 with clean water. Use the mix the same day.

Can I use it while polishing?

Yes, from resin pads grit 100. Apply at least 2 layers after 2 different polishing steps; continue polishing once the surface no longer glistens.

Need the technical or safety data sheet? Email us at info@broosindustrialfloors.com or use our contact page and we will send it right away.